MODEL 2310 AL MCS-11 REMOTE ENCODER
FIAL INCORPORATED
FC2310_AL-20040506
13
PROGRAMMING
An included Windows based program is used to configure the MCS-11 Encoder. The configuration
data is transferred between the PC and the MCS-11 Encoder's craft port using COM 1, 2, 3, or 4.
To install the software, simply copy the file named "FC2310.exe" from the supplied floppy disk to
your hard disk, or run the program directly from the floppy disk.
Enter the appropriate configuration settings as described below. When you run this program, the
following main screen appears:
Figure 9. GENERAL PAGE (DEFAULT)
The program has a set of four tabs that you may use to select different views or 'pages'. The first
page is called General, and is concerned with configuration settings that apply to the Model 2310
AL unit as a whole. The following sections explain each setting.
MCS-11 ALARM ENCODER STATION ADDRESS:
The Station address desired for the 2310 AL
must be set properly. The address range is
A
through
H
and
1
through
16
(128 possible
addresses). Note: Address
H16
should
not
be used if you are planning to use multiple MCS-11
polling engines with poll synchronization.
