FHM BACKHOE BH 8, Operation And Parts Manual

Page: 14 / 43

Farmer-Helper BH 8 & 9 14 Revision 08 - 2017
5.1 PT O CONNECT ION
Ensure PTO shaft is correct length, correct PTO shaft length must have a minimal overlap of
2” in drive position. See PTO Driveline manual for proper steps to reduce overall PTO
driveline length. Connect PTO shaft to tractor, PTO output shaft and backhoe hydraulic pump
shaft. Check PTO shaft has suitable angle prior to operation. Angle of PTO shaft universal
must be less than 25 degrees, to prevent major damage.
CAUTION: Backhoe should be mounted to the tractor three point linkage.
CAUTION: Never store backhoe without bucket attached to the backhoe.
CAUTION: Never raise 3-PT position/draft lever while backhoe is
connected, damage could occur to linkage and hydraulic system or
void the warranty. Use mechanical means to secure levers in down
positions.
CAUTION: It is Owner/Operator responsibility to
ensure that the tractor three point top link, tractor
frame & hydraulic lift cover area is strong enough to
accept three point rigid connection and backhoe force
while in operation as extra forces are exerted through
3-PT hitch system. No liability can be accepted for
damage to tractor.
We recommend that 3-point lift capacity at 24”
beyond the end of the lift arm be at least equal to the
weight of the backhoe.