5
Place in a safe position
Position your vaporiser on the floor at least 1.2 meters away
from any person.
Ensure the room is well-ventilated so air is free to circulate
to prevent excess humidity (e.g. keep door slightly ajar).
Make sure the cord lies flat and out of the way.
For extra floor or carpet protection, place your vaporiser on a rubber mat or other heat
resistant, non-metallic barrier.
Do not place vaporiser on a table, chair or other piece of furniture
6
Plug into power point
Plug into power point and switch on power. Your vaporiser will produce steam within
3-4 minutes. Ensure you have sufficient water for each use.
7
Switch off after use
Always switch off your vaporiser at the power point after use, or as soon as it has
finished steaming. Failure to switch off your vaporiser when it is no longer steaming
may void any warranty claims.
After power is switched off, unplug your vaporiser from power point for cleaning.
Night light: The safety night light ensures your vaporiser is visible at all times, and will remain on as
long as there is power. This acts as a reminder for you to switch off the power after use.
8
Clean vaporiser
Cleaning your vaporiser is very important. To help keep your vaporiser clean and
germ-free, empty the water container and rinse after each use. Also rinse the base of the
unit (do not submerge power cords in water). Dry all parts thoroughly.
Do not use any cleaning products on vaporiser. Continue to use the Cleaning Tablets during
regular operation.
CAUTION: SAFETY INFORMATION
Euky Bear is safety conscious when designing and manufacturing consumer products. It is also
essential the product user exercises care when using an electrical appliance.
Listed below include important safety precautions, essential for the safe use of this appliance:
• Vaporiser produces hot steam which can scald. NEVER touch the steam outlet while unit is in use.
• Keep out of reach of children and ensure children cannot access the unit while in use.
• Do not overfill.
• Disconnect the power cord before filling, cleaning or moving.
• Turn off after steaming is complete. Do not operate the unit when removed from the vaporiser
water tank.
IMPORTANT: Ensure vaporiser is unplugged during set up.
1
Remove unit
Remove unit by gently twisting anti-clockwise. This will unlock
the unit and allow you to easily lift it out of the water container.
2
Add inhalant and cleaning tablets
First shake Euky Bear Inhalant bottle, then add 2 capfuls into empty water
container before filling with water, to ensure it is well mixed.
When using Euky Bear Cleaning Tablets, place one tablet
in the centre of the water container before filling with water.
It is recommended to use Cleaning Tablets when using your vaporiser
for the first time, as well as with every 3rd or 4th use to keep it running at
optimal condition. Cleaning Tablets are non-toxic and designed to be used during normal
operation. No separate cleaning cycle required.
NOTE: In areas with hard or mineralised water, use two Cleaning Tablets each time you use
your vaporiser. Do not add any other substances (ie. salt) to change the water quality.
The vaporiser will operate efficiently in all kinds of water.
3
Add water
Add water to container, up to the maximum fill line as indicated
on the sides of the water container. Do not overfill.
Rinse and refill with fresh water each time you use your vaporiser.
4
Re-insert unit
Re-insert unit, gently twisting clockwise to lock it into place.
Instructions