BATTERY
INSTALLATION
CHARGING THE
HELICOPTER
Open the battery cover and
insert 6 (AA) batteries. Make
sure they are inserted with the
correct polarity. Then replace
the battery cover.
Connect to a
USB port
Remote control charging:
1. Turn the remote control (ON), turn the helicopter power (OFF).
2. Take out the charging wire from the compartment in the remote control.
3. Connect the helicopter up to the remote control.
4. When the LED light on the front of the remote control turns from RED to GREEN charging is completed.
USB Charging:
1. Plug the USB lead in to a computer or USB input.
2. Turn the helicopter (OFF)
3. Connect the lead to the helicopter.
4. When the RED light on the USB switches OFF, charging is completed.
A FULL CHARGE TAKES UP TO 45 MINUTES AND WILL LAST FOR 6 MINUTES.
- Set the Infra-Red channel selector on the remote control to the same as the helicopter.
- Turn the remote control and then the helicopter (ON)
- Place the helicopter on a flat surface.
- Increase the power on the controller.
- The lights will start flashing on the helicopter and then you can start flying!
To make the helicopter move UP push the left
hand power stick up.
To make the helicopter move DOWN move the
left hand power stick towards you.
Use only small movements for smooth flying.
To make the helicopter spin to the LEFT, move
the right hand direction stick to the LEFT.
To make the helicopter spin to the RIGHT, move
the left hand direction stick to the LEFT.
To move FORWARDS, push the right
hand direction stick FORWARD and the
helicopter will move FORWARD..
To move the helicopter BACKWARDS, move the
left hand direction stick BACKWARDS and the
helicopter will move BACKWARDS.
To turn the bubbles ON, push the left hand
button on the top of the controller and the
helicopter will shoot bubbles out of the back of
the helicopter.
To fill the bubble tank, use the squeeze bottle
and siringe end. Fill the squeeze bottle up with
bubble fluid then squeeze in to the bubble tank
access hole.
If the helicopter is moving to the left or the right without any
control inputs. Then you will need to trim the helicopter.
HELICOPTER SPINS TO THE RIGHT
HELICOPTER SPINS TO THE LEFT
Press the L side of the trim button on the
remote control. Continue pressing until it
stops spinning to the right.
Press the R side of the trim button on
the remote control. Continue pressing
until it stops spinning to the left.
BATTERY INSTALLATION & CHARGING
FLYING THE HELICOPTER
FLY UP AND DOWN
TURN LEFT/RIGHT
FORWARDS
BACKWARDS
BUBBLES
NOTE ON REFUELING BUBBLES
TRIMMING THE HELICOPTER
