WARNING
This product may contain substances known to the
State of California to cause cancer, birth defects or
other reproductive problems. Wash your hands after
installing or repairing the ffuuss
TM
handryer
2.
GENERAL NOTES
The instructions included in the attached installation
manual must be followed carefully when installing a
ffuuss
TM
handryer
2.
ffuuss
TM
will not be liable for any damage to property
or personal injury or death resulting from
non-compliance with the instructions contained
herein and in the installation manual.
Make sure your ffuuss
TM
handryer
2
works properly
before allowing the public to use it.
Do not use the ffuuss
TM
handryer
2
for any purpose
other than drying hands.
Using authentic ffuuss
TM
spare parts can extend the
correct and safe functioning of your unit.
HOW TO USE
Place hands in the drying area of the ffuuss
TM
handryer
2
to activate the machine and the air
outlet. Keep hands in the drying zone until the
cycle ends.
TROUBLESHOOTING
IMPORTANT: TURN OFF THE ELECTRICAL SUPPLY TO THE ffuuss
TM
BEFORE SERVICING IT.
CLEANING THE DEVICE.
Surfaces.
Only clean the surfaces of the ffuuss
TM
handryer
2
with a damp cloth. Do not use abrasive or caustic
products.
MAINTENANCE ADVISE.
Air intake.
Check the air intake through the base of the ffuuss
TM
handryer
2
regularly and make sure that it is free from
dust, dirt or any other particles. Also make sure that
all the surfaces of the ffuuss
TM
handryer
2
are
properly cleaned to ensure the correct functioning.
TEST
Make sure the power supply is connected to the
ffuuss
TM
handryer
2
. Place hands in the drying area
of the ffuuss
TM
handryer
2
to activate it and the air
outlet. Keep hands in the drying zone until the
cycle ends. Remove hands from the ffuuss
TM
handryer
2
and it will turn off automatically.
Problem
Action
If the problems persist
The
ffuuss
TM
handryer
2
does not start.
Make sure the
ffuuss
TM
handryer
2
and the
wiring are properly connected. Check that it is
turned on.
Contact your authorised
dealer, or us directly at the
following email address:
[email protected]
or by calling
+34 902 883 083
The
ffuuss
TM
handryer
2
starts and turns off
erroneously.
Check that there are not any objects or obstacles
in the drying area, if so, remove them.
Sometimes the
ffuuss
TM
handryer
2
turns off
when it is in use and then starts again after
a while.
Check that both the drying area and the air
intake at the base are dust-free and clear
from any obstructions, if so, remove them.
The
ffuuss
TM
handryer
2
continues to function
after hands have been removed.
A 2 seconds delay after hands have been
removed is acceptable.
Air comes out of the front or the rear of the
ffuuss
TM
handryer
2.
Check there is nothing obstructing the air
intake or outlet. If there is, remove it.
The
ffuuss
TM
handryer
2
is not drying hands
properly.
Check there is nothing obstructing the air
intake. If there is, remove it.
The
ffuuss
TM
handryer
2
works only for a
couple of seconds and then it turns off.
Water accumulates in the base of the
ffuuss
TM
handryer
2.
Make sure the drain outlet is not blocked. If it
is, clean and unblock it with the brush.
The
ffuuss
TM
handryer
2
reflects a red light.
The water tank is full. Empty it and put it back.
The red light will turn off.
The ffuuss
TM
handryer
2
flashes a red light in
the upper part of the front pannel, while all
other lights are turned off.
Call or contact your dealer.
www.ffuuss.com
Check that there are not any objects or obstacles
in the drying area, if so, remove them.
NOTE:
ffuuss
TM
reserves the right to make changes without prior notice.
