2/3
530/04
MFS profile
Centre of
rotation
Set screw
Cutter
centre
Cutter
inner dimension
Cutter
outer dimension
530/03
1. Screw
2. Free movement
530/02
B
Required equipment
Equipment
Order No.
Routing template MFS 400
or routing template MFS 700
492610
492611
Router OF 1010 or
router OF 1400 or
router OF 2200
*
*
*
Copying ring holder (included with MFS)
Copying ring dia. 30 mm
(included with OF 1400 and OF 2200)
Groove cutter
*
CT series mobile dust extractor
*
• 8 mm drill bit with centring point
492517
* Please obtain the Order No. from the Festool main catalogue or from its website.
Preparation/Set-up
Mount the routing template according to the directions, and install the copy-
ing ring holder and centring mandrel (see Section 5.4 in the instructions).
Adjust the copying ring holder so that it can move freely along the entire
length of the MFS groove. To do this, slide the copying ring holder in a
corner and fasten securely with the fixing screw (Fig. 530/03). Finally, move
the copying ring holder into the other corner, tighten the fixing screw on the
MFS and the check the free movement of the copying ring holder over the
entire length.
Setting the routing template
1. For an outer radius:
Set the radius minus ½ cutter dia. using the scale on the MFS,
e. g., radius 200 mm – (cutter dia. 14 mm / 2) = 193 Move the "0" on the
copying ring holder vernier scale so that it coincides with the number
193 on the MFS scale.
2. For an inner radius:
Set the radius minus ½ cutter dia. using the scale on the MFS,
e. g., radius 200 mm + (cutter dia. 14 mm / 2) = 207 Move the "0" on the
copying ring holder vernier scale so that it coincides with the number
207 on the MFS scale.
Clamp the copying ring holder to the lower part of the MFS.
•
C
