Mitre Saw
Page 5
Dust Extraction
Connect the saw to a dust extractor to reduce dust during operations on wood.
NOTE
Extraction must
NOT
be used when cutting Aluminium.
Ensure the dust extraction port is facing away from others who are working in the space.
Plug the power tool cable into the front of the extractor and set to full suction and Auto.
Operation
Setting the Motor Speed The optimal speed of the saw is predominately determined by the type
of material being cut. Turn the speed control dial to the number shown in the table to the left. The
speeds listed in the table are just rough guidelines, and actual results may vary.
Laser Guide
CAUTION!
Laser Radiation. Do not look directly into the laser beam.
The laser system scans across the path of the sawblade to indicate
where the blade will cut the workpiece.
The two laser beams shine down on the workpiece on either side of
the sawblade. The sawblade will cut the workpiece between the two
laser lines.
To turn on the laser, press the On/Off button on the rear of the motor
near the speed control dial. Pressing the button a second time will
turn the laser off. The laser will also automatically shut off if left on for
more than approximately 30 minutes.
