14
Q U A D R I L L
GB
8.3
Angle attachment [5]
The angle attachment (partly as an accessory) al-
lows the user to drill and fasten at right angles to
the machine.
Prior to initial use:
apply some multi-purpose
grease to the drill spindle and the gearbox neck.
8.4
Depth stop [6]
The depth stop (partly as an accessory) allows the
user to insert screws to a predefined depth. You can
set the dimension by which the screw head pro-
trudes above or is recessed below the surface of the
workpiece.
Depth setting
Turn the housing
[6-1]
to set the
desired fastening depth. Each
detent position changes the fas-
tening depth by 0.1 mm.
Sleeve A/B must be removed before a screw can be
unscrewed.
8.5
Tool holder in the drill spindle [7]
Bits can be inserted directly into the hexagon sock-
et holder of the drill spindle.
9
Working with the machine
Please observe all mentioned safety infor-
mations and the following rules when work-
ing:
– Only use tools designed for the specified maxi-
mum speed.
– Only sharp tools ensure efficient drilling and pre-
vent machine overload.
– Always use faultless, sharpened HSS drill bits
(HSS: High Speed Steel) when drilling into metal.
– Do not cause the machine to seize through over-
loading.
– Always switch off the machine before placing on
the nut/screw.
– Caution: when inserting long screws, there is a
risk the bit may slip from the screw head and
cause injury.
– Machine vice: clamp the workpiece securely in a
machine vice, for example, before drilling to pre-
vent the workpiece from turning and causing ac-
cidents.
9.1
Bit depot [1-1]
Magnetic, for storing bits and bit holders.
9.2
Belt clip [1-9]
The belt clip (right/left) allows the user to attach
the machine briefly to work clothing.
9.3
Lighting
ON: Press the LED light switch
[1-3]
.
OFF: Press the LED light switch
[1-3]
again.
The light remains switched on for approx. 20 s
after the machine is disconnected from the
mains power.
9.4
Warning signals
Acoustic warning signal
An acoustic warning signal sounds and the ma-
chine switches off in the following operating states:
Visual warning signal
A visual warning signal is issued and the machine
switches off in the following operating states:
10
Service and maintenance
Customer service and repair
only
through manufacturer or service
workshops: Please find the nearest
address at:
www.festool.com/Service
Use only original Festool spare parts!
Order No. at:
www.festool.com/Service
To ensure constant air circulation, al-
ways keep the cooling air openings in
the motor housing clean and free of blockages.
Machine overloaded.
LED
[1-3]
Red - flashing
Machine has overheated.
Press the Speed set button
[1-
4]
to switch the machine to
recovery mode.
Do not place
under load
! The machine
reverts to normal operating
mode once the machine has
cooled, if the Speed set button
or on/off switch are pressed or
the machine is placed under
load.
WARNING
Risk of injury, electric shock
Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!
All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
peep peep peep
EKAT
1
2
3
5
4
