Festool 205721, Original Instructions Manual

Page: 22 / 228

completely charged with plugged in charg­
ing cable [1-11].
LEDs light up in
starting sequence SYS‑PST 1500 Li HP powers up or starts.
LED 1 flashes green Ready for operation
SYS‑PST 1500 Li HP almost completely dis­
charged.
Charging (see section 7.2 ).
1 > LED < 8 light up
green Ready for operation
Number of continuously lit green LEDs cor­
responds to state of charge.
All LEDs continuous­
ly light up green Ready for operation
SYS‑PST 1500 Li HP is charged.
1 > LED < 8 light up
green
Remaining LEDs
light up green in se­
quence from left to
right Not ready for operation, charging mode
SYS‑PST 1500 Li HP charging.
Number of lit green LEDs corresponds to
state of charge.
7.5 Troubleshooting
1 > LED < 8 light up
yellow Overcurrent
AC output [1-3] has been deactivated.
Switch off (see section 7.3 ).
Wait for 10 seconds.
Switch on (see section
7.3 ).
1 > LED < 8 flash yel­
low
Overheating
AC output [1-3] has been deactivated or
charging process has been interrupted.
In operating mode:
Switch off (see section 7.3 ).
Wait until SYS‑PST 1500 Li HP has
cooled down.
Switch on (see section 7.3 ).
If LEDs continue to flash yellow, switch
off again (see section 7.3 ) and leave to cool
down further.
English
22