Festool 204137, Original Instructions Manual

Page: 20 / 140

[1-12] Knob for angle setting
[1-13] Cutting depth adjuster
[1-14] Capacity display button on battery
pack
[1-15] Capacity display
[1-16] Battery pack
[1-17] Button for releasing the battery pack
[1-18] Adjustable jaws
The illustrations specified are located at the be­
ginning and end of the operating instructions.
Accessories shown or described are not always
included in the scope of delivery.
6 Battery pack
► Inserting the battery pack [2B]
► Removing the battery pack [2A]
6.1 Capacity display
The capacity display [1-15] indicates the charge
of the battery pack for approx. 2 seconds after
the button [1-14] is pressed:
70‑100%
40‑70%
15‑40%
< 15% *
*
Recommendation: Charge the battery pack
before any further use.
Further information about the battery
pack and charger can be found in the
corresponding operating manual.
7 Settings
WARNING
Risk of injury, electric shock
► Always disconnect the battery packs from
the machine before performing any type of
work on the machine!
7.1 Electronics
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
Constant speed
The motor speed remains constant through
electronic control to ensure a uniform cutting
speed even when under load.
Current limiting
Current limiting prevents excessive current
consumption under extreme overload, which
can lead to a decrease in the motor speed. The
motor immediately restarts after the load is re­
moved.
Brake
The HKC 55 EB is fitted with an electronic
brake. When the saw is switched off, the saw
blade slows to a stop electronically within ap­
prox. 2 seconds.
Restart protection
The integral restart protection prevents the
electric power tool from automatically starting
up again after an interruption in power when
the ON/OFF switch is pressed. In this case the
electric power tool must be switched off and
then switched back on again.
Temperature cut-out
When exceeding a certain engine temperature
level, the machine power supply and speed are
capped. The power tool continues operating at
reduced power to allow the ventilator to cool
the motor rapidly. The power tool resumes to
full performance automatically once the motor
has cooled sufficiently.
7.2 Adjusting the cutting depth
The cutting depth can be set at 0 – 55 mm.
► Press cutting depth adjustment
[3-1] .
► Pull up or push down saw at main handle.
Cutting depth without guide rail/track
rail
max. 55 mm
+FS
Cutting depth with guide rail/track rail
max. 51 mm
7.3 Adjusting the cutting angle
The saw table must be on an even
surface when adjusting the cutting
angle.
Between 0° and 50°:
► Open the rotary knob [4-2] .
► Swivel the saw unit to the desired cutting
angle [4-1] .
► Close the rotary knob [4-2] .
English
20