Festo VMPA...-FB-EPL Series, Electronic Manual

Page: 180 / 232

6. Multi I/O modules
6−10
Festo P.BE−CPX−EA−EN en 0705f
6.4 Instructions on commissioning
The reaction of the I/O modules can be parametrized.
The table below gives an overview of the parameters.
Further information on parametrizing can be found in the
system manual or in the manual for the field bus node.
Parameters of the multi I/O modules
typeCPX−8DE−8DA
Module parameters: Monitoring the CPX module
Function no. 4828 + m * 64 + 0 m = module number (0...47)
Description Monitoring of the possible faults can be activated or deactivated (suppressed)
for each module independently. Active monitoring causes the following:
The fault is:
sent to the CPX field bus node
displayed by the module common error LED
Bit
0
1
2
Monitoring
Description
Short circuit/overload in sensor supply (SCS)
Short circuit/overload at the outputs (SCO)
Undervoltage at outputs (V
OUT
)
[Monitor]
[Monitor SCS]
[Monitor SCO]
[Monitor Vout]
Values 1 = active (presetting)
0 = inactive [Active]
[Inactive]
Remark Monitoring can also be set for the complete CPX terminal
(see System parameter monitoring")
Tab.6/5: Monitoring the CPX module