Festo VABA-10S6-X Series, Manual

Page: 79 / 196

2. Digital CPX input modules
2−31
Festo P.BE−CPX−EA−EN en 0804g
2.4 I ns t r uct i o ns o n c o mm issi o nin g
The reaction of the I/O modules can be parameterized.
The table below gives an overview of the parameters.
The appendix of the System Manual contains further
information on parameterizing. There you will find:
time diagrams on the course of the input debouncing
time and the signal extension time
details on Forcing and on Fail safe and Idle mode.
2.4.1 Parameters of the input modules
M od u l e p a r a mete r s : M o ni t or in g t h e C P X m od u l e
Function no. 4828 + m * 64 + 0 m = module number (0
Ū
47)
Description Monitoring of the possible faults can be activated or deactivated (suppressed)
for each module independently. Active monitoring causes the following:
The fault is:
sent to the CPX bus node
displayed by the module common error LED.
Bit
0
Surveillance
Description
Short circuit/overload in sensor supply (SCS) [Monitor]
[Monitor SCS]
Values 1 = active (presetting)
0 = inactive [Active]
[Inactive]
Note Monitoring can also be set for the complete CPX terminal
(see System parameter monitoring").
Tab.2/27: Monitoring the CPX module