Festo VABA-10S6-X Series, Manual

Page: 129 / 196

4. Digital CPX multi I/O modules
4−11
Festo P.BE−CPX−EA−EN en 0804g
Module pa r amete r s : Signal e x tension time
Function no. 4828 + m * 64 + 1 m = module number (0
Ū
47)
Description Determines the signal extension time for the relevant I−module. Signal states
accepted as logical input signals usually remain valid at least until the specified
signal extension time (minimum signal duration) has expired. Changes of edge
within the extension time are ignored.
Bit Bits 6, 7
Values
Bit 7 6
0 0
0 1
1 0
1 1
Signal stretching time
Description
0.5 ms
15 ms (presetting)
50 ms
100 ms [Signal extension]
Note There is a danger that short signals are not recognized" due to long cycle times
of the higher−order controller. In order that such signals are also taken into
consideration in the control sequence, a signal extension time can be specified
(see section CPX system manual). The signal extension time can be activated
channel−by−channel (see channel−specific module parameters).
Tab.4/8: Signal stretching time
Module pa r amete r s : Signal e x tension c h annel x
Function no. 4828 + m * 64 + 6 m = module number (0
Ū
47)
Description Determines whether the signal extension for the relevant I−channel is to be
enabled or blocked.
Bit Bit 0
Ū
7 (channel 0
Ū
7)
Values Signal extension input channel ...
0 = blocked (presetting)
1 = enabled [Signal extension Inp Ch ...]
[Disabled]
[Enabled]
Note The signal extension time can be specified separately for each module
(see function no. 4828 + n; n = m * 64 + 1).
Tab.4/9: Signal extension channel x (channel−specific)