The voltage range is 0 - 10 V. You can set any movement of
the axis within its possible range of movement by program via
an analogue nominal value.
3.1 Connecting analogue nominal value voltages
WARNING
Incorrect installation can result in operating problems and
e.g. cause unwanted movements of the actuator. Be sure to
observe the following installation instructions.
•
Use a screened twisted-pair cable for setting the analogue
nominal values.
•
Do not route signal cables near or parallel to cables with
high interference levels. If necessary use separate wiring
ducts, separate wiring harnesses or separate cables.
•
Always connect one side of the screening for analogue
signal cables to the earth connection (pin 9).
Recommendation: Keep signal cables as short as possible. The
cables should not exceed 4 m in length.
En
gl
is
h
SPC200-2AI-U
0503b
15