Vision Sensor SBSI/SBSC-EN, 8062650 - 1607b - 13/09/2016
Page 251
Vision Sensor Manual
Fig. 262: Ram Disk via DOS
Attention:
* The format of all .csv files (ftp, smb, ram-disk, Vision Sensor Visualisation Studio) is always the same.
* The data is readable (by default divided with semicolon comma) stored into the .csv file.
* Only (payload) data, which have been defined under Output/Telegram are transmitted.
5.2 Backup
5.2.1 Backup creation
To save all setting of the sensor, which have been made to check one or some parts, please store all these
settings with the command „Save job as ...“ or „Save job set ...“ in Vision Sensor Configuration Studio/File.
With the commands „Load job ...“ or „Load job set ...“ these settings can be restored to the sensor later.
5.2.2 Exchange SBS
Before exchanging a sensor store all necessarily settings (as described in chap.
.) By
exchanging one SBS -Sensor against another please consider that the sensors are not calibrated optically
or mechanically. That means the new sensor must be: installed mechanically and electrically like described
in chap.
ff. And also must be optically focused and set up correctly to work in the network.
After this the in advance stored parameter settings can be restored from the PC to the sensor.
Summary of Contents for SBSC-EN
Page 1: ......
