Festo MPA-ASI Series, Manual

Page: 40 / 208

1. Summary of components
1−22
Festo P.BE−MPA−EN en 0802c
Vertical stacking
You can fit further pneumatic components in each location
between the manifold sub−base and the valve. These compo
nents will enable you to implement certain additional effects
as desired. The following components are available:
Component
Single−solenoid
5/2−way valves
Alternative:
two 3/2−way valves or a
5/2−way double−solenoid valve
or a 5/3−way mid−position valve
Alternative:
Cover plate, for sealing an unused
valve location type MPA....
Pressure regulator plate type: VMPA....B8−R...C2−C−...
(with or without pressure gauge).
The Tab.1/10 provides an overview of the available variants of
the pressure regulator plates.
The function of the most important pressure regulator plates
is described in the following section.
Vertical stacking, optional components:
1)
Sub−base type MPA....−...−AP−... with electronic module type
VMPA...−...−EM...
1)
Notes on installing the vertical stacking components see chapter 3
Tab.1/9: Components of the pneumatic module of the MPA−S valve terminal