Festo EXCM-10-***-E, Translation Of The Original Instructions

Page: 62 / 84

7 Diagnostics
62 Festo – EXCM-10/-30-...-E-EN – 1612b – English
7.4 Malfunctions: Causes and remedy
7.4.1 Error responses
The following responses to errors are intended. For each error, the error messages table specifies
which response is set at the factory (printed in bold face) and which additional responses can be para­
meterised.
Code letters and description of the error responses
A Free run-out Switch off output stage, no braking ramp.
B
QS decele output stage off Fast stop braking ramp (quick stop), then switch off
output stage.
C Positioning job decele output
stage off
Braking ramp (of the current positioning job), then
switch off output stage.
D Terminate positioning job + output stage
off
Execute positioning job to the end (until MC = 1),
then switch off output stage.
E
QS decele output stage on Fast stop braking ramp (quick stop), then output
stage remains switched on.
F Positioning job decele output
stage on
Braking ramp (of the current positioning job), then
output stage remains switched on.
G Terminate positioning job + output stage
on
Execute positioning job to the end (until MC = 1),
then output stage remains switched on.
Tab. 7.3 Error responses
7.4.2 Table of error messages
You can parameterise the error messages via the Festo Configuration Tool (FCT) on the
page “Parameterise error management”.
Explanations for table of error messages:
Can be parameterised as:
F /W/I = fault/warning/information (
è
7.2 Types of malfunctions).
Specifies the parameterisation options for an error message. The factory setting is printed in bold
(here, error).
If a parameterisation option is not available, this is indicated by dashes, e.g. “F/-/-” if the error mes­
sage is treated exclusively as a fault.
Diagnostic memory
Always/optional: Specifies whether an entry is generally made in the diagnostic memory or whether an
entry can be parameterised via the FCT.
Software reset
Restart of the controller, either by switching off and back on or via the FCT in the menu [Components /
Online / Restart controller].
Error response(s)
A list of the error responses (
è
7.4.1 Error responses). The factory setting of the error responses is
always printed in bold.