Festo CPX-FB38, Electronic Manual

Page: 25 / 120

1. Installation
1−9
Festo P.BE−CPX−FB38−EN en 0804NH
Setting the operating mode with DIL switch
1
You can set the operating mode of the bus node with switch
element 1.1 of DIL switch
1
(see Tab.1/1):
Remote I/O operating mode
Operating mode Remote Controller
Operating mode Setting DIL switch 1
Remote I/O operating mode
All functions of the CPX terminal are controlled directly by the
EtherCAT−IO controller or a superordinate PLC.
The bus node thereby takes over the connection to the
EtherCAT network.
DIL 1.1: OFF
DIL 1.2: OFF
(factory setting)
Operating mode Remote Controller
Requirement:
a CPX−FEC is an integral part of the CPX terminal.
The FEC integrated in the terminal controls all functions.
The bus node thereby takes over the connection to the
EtherCAT network.
DIL 1.1: ON
DIL 1.2: OFF
Tab.1/1: Setting the bus node operating mode with DIL switch 1