34 / 55
Festo 7DFPIb_en
3. Unscrew the external mounting screw.
4. Remove the electronic function module.
Installing the electronic function module
1. Position the electronic function module in the correct position relative to the
two retainers.
2. Fit the retaining washer on the two mounting screws so that the washer
teeth are facing away from the screw head.
3.
Screw in both mounting screws to a tightening torque of 0.5 Nm ±10%.
4. Plug in the bottom plug connector.
The colours of the individual wires in the cable harness are as follows from
top to bottom (end cap facing downwards):
Brown
White
Blue
Black
Grey
5. Plug in the top plug connector.
The colours of the individual wires in the cable harness are as follows from
left to right (end cap facing downwards):
Grey
Black
Blue
White
Brown
Installing the controller
Note
When installing the controller, make sure that there are no kinks or tension in the tubing or cables. Kinked lines are
susceptible to premature faults and will result in failure of the linear actuator.
