9
The temperature that has been set can be
brought into view by pressing upper button
of the display for about 2 seconds. The
display will begin to flash, showing the set
temperature. After a while, the flashing will
stop and the set temperature will remain in
force.
Adjusting the temperature
•
Press the display button (upper or
lower) until the display begins to flash.
•
Using the button (upper button up,
lower button down), select the desired
temperature and leave it visible.
•
The selection has now been made,
and no separate confirmation is
needed.
•
The display will return to showing the
interior temperature.
The temperature that has been set can be
brought into view by pressing the button
(upper or lower) of the display for about 2
seconds. The display will begin to flash,
showing the set temperature. After a while,
the flashing will stop and the set temperature
will remain in force.
Sounds during operation
Resonance noise may be produced if the
appliance is not completely straight - or if
parts of the pipe system are touching one
another, in which case the pipes can be
bent apart carefully by hand.
Cooling system
When the refrigerant is being pumped
into the piping, a hissing or bubbling
sound is heard.
Compressor
When the refrigerant is being pumped, a
droning or “snoring” noise is heard from
the compressor motor and the pump.
Fan
When the compressor starts up, the fan
inside the cabinet also starts up at the
same time.
This causes a low humming, which is
heard throughout the period when the
compressor is running.
Normal sound of the cooling cabinet
The wine cabinet acquires its coldness
from the compressor operated cooling
system.
For this reason, it is completely normal
that the appliance makes a certain sound.
The sound level can vary. The loudness of
the sound is influenced by, for example,
how the cabinet has been installed in pla-
ce, how it is used, and how old it is.
Cleaning
CLEANING THE WINE CABINET
Stop the mechanism of the wine cabinet
using the main switch, for the period during
which the interior surfaces are being
cleaned.
The cleaning water must not be allowed to
get into the control devices (nor into the
lighting in the glass-doored model).
You can clean all the interior surfaces using
lukewarm water with a little washing-up
liquid added. Scouring agents or solvents
are not suitable for cleaning the cabinet.
Dry the interior and the seal thoroughly.
