FESTA Power X Tools 28055, Manual For Use

Page: 6 / 41

6
•
The saw blade can be inserted into the self-locking head upside down by 180 ° to cut
upwards or to make a plunge cut at a smaller angle.
INSERTING THE BATTERY INTO THE HANDLE ACCOMPANYING THE
RECIPROCATING SAW
•
Insert the battery into the handle of the saw blade until it clicks into place.
USING CORDLESS RECIPROCATING SAW
•
Before cutting the saw blade into the material to be cut, the saw blade must vibrate and the
support must be supported by the workpiece
•
Overhanging building elements, such as steel reinforcement, plastic pipes, etc., can be cut
directly at the wall.
•
For cutting directly at the wall, it is necessary to choose a longer saw blade so that it can
be bent more without rubbing against the edges of the support foot window.
•
Use the saw blade designed for the material.
•
Place the saw with the foot on the base and lift the saw so that the saw blade is bent and
clamped to the ground and guide the bent saw blade to the surface of the material to be
cut. Cut the protruding material with adequate pressure on the saw blade.
CUTTING HOLLOW OBJECTS
•
Always make sure that the length of the saw blade is larger than the diameter of the
workpiece with sufficient margin. Otherwise there is a risk of the saw blade getting stuck in
the hollow cut material and kickback, the support must be fastened to the cut material.
IMMERSION / ARC CUTS
•
Only soft materials such as wood, plasterboard, etc. may be machined by the gradual
immersion method. Never use this method when machining metallic materials.
•
Use only short saw blades for plunge cutting.
•
Support the saw with the edge of the support against the surface of the material to be
machined.
•
Bring the saw to the maximum number of oscillations by pressing the operating switch as
far as possible and slowly lift it up while the support on the cut material is closed so that the
saw blade is cut into the material until the saw rests on the entire surface of the material
support (the support adjusts the inclination cut material). Then guide the saw with adequate
pressure on the saw back to cut the required line. For certain jobs, such as cutting at the
ceiling or for a smaller angle of inclination of the saw blade to the surface of the material to
be cut, the saw blade can be used rotated 180 ° and the hacksaw can be guided inverted.
SAFETY INSTRUCTIONS FOR TOUCH CORDLESS RECIPROCATING SAW AND
MULTIFUNCTIONAL OSCILLATION TOOLS
1. When performing an operation where a cutting or other tool may touch a hidden guide or
its own supply, hold the power tool by the gripped insulated surfaces. Contact of the tool
with a "live" wire can cause the non-insulated metal parts of the electromechanical tool to
become alive and can lead to electric shock to the user.
2. Clamps or other practical means shall be used to secure and support the workpiece on a
stable base. Holding the workpiece by hand or against the body leads to its instability and
can lead to loss of control.