Ferroli OMNIA HYBRID C, Installation, Maintenance And User Manual

Page: 64 / 116

64
EN
Cod. 3541T090 - Rev. 00 - 06/2019
BOILER CONTROLLER - USER MENU
9. BOILER CONTROLLER - USER MENU
9.1 Control panel boiler
fig. 151 - Control panel
Panel legend fig. 151
1 DHW temperature setting decrease button
2 DHW temperature setting increase button
3 Heating system temperature setting decrease button
4 Heating system temperature setting increase button
5 Display
6 “Sliding Temperature” Menu - Reset button
7 Mode selection button: “Winter”, “Summer”, “Unit OFF”, “ECO”, “COMFORT”
8 Eco (Economy) or Comfort mode
9 DHW mode
10 Summer mode
12 Multifunction (flashing during exchanger protection function)
13 Heating
14a Burner lit (flashing during calibration function and self-diagnosis phases)
14b Appears when a fault has occurred causing the unit to shut down. To restore
unit operation, press the RESET button (detail 6)
17 External sensor detected (with optional external probe)
Indication during operation
Heating
A heating demand (generated by the Room Thermostat or Remote Timer Control)
is indicated by activation of the radiator.
The display (detail 12 - fig. 151) shows the actual heating delivery temperature
and, during heating standby time, the message “d2”.
fig. 152 -
Domestic hot water (DHW)
A DHW demand (generated by drawing hot water) is indicated by activation of
the faucet.
The display (detail 12 - fig. 151) shows the actual DHW outlet temperature and,
during DHW standby time, the message “d1“.
fig. 153 -
Comfort
A Comfort demand (reinstatement of temperature inside the boiler) is indicated by flashing of the Comfort symbol. The display (detail 12 - fig. 151) shows the actual
temperature of the water in the boiler.
Fault
In case of a fault (see
“11.2 Boiler faults”
) the display shows the fault code (detail 12 -
fig. 151
) and during safety pause times the messages “d3” and “d4”.