Ferroli LEB 12.0-TS, User And Installation Manual

Page: 9 / 24

P08 range: 02 to 12. Each sequence start and stop two groups, start-stop interval is 5 seco
-nds, start and stop order is: R01 & R07
→
R02 & R08
→
R03 & R09
→
R04 & R10
→
R05 & R11
→
R06 & R12.
1.7.Menu
In the status without settings and faults, keep the reset key pressed for 10 seconds to access the
menu.
By the heated rotary knob, can skim through the“TS”
、
“
HI” and“RE”menu.
Details explain as below:
“TS”means adjustable menu.
“HI” means recall menu.
“RE”means reset menu.
Press the set button to step into relevant menu.
“Ts”means adjustable menu.
After finishing the setting , press the OK key to exit and store the performed changes . In the case in which
you do not want to store the performed changes , shortly press the reset key to leave the menu .
After start the outdoor temperature compensation function , if detect there ' s faults on the outdoor
temperature probe , it will show the fault code ( F13 ) every 10S . Under this situation , the system will not
operate according to the pre - set outdoor temperature compensation curve , and the heated water target
temperature will be acquiesced in 60 C . Under this situation , user can adjust the water target temperature
by means of adjusting the rotary knob .
6
P01: To set the water pump operation period when the unit is stopped;
P02: To set the temperature difference between the flow pipe and the return pipe in the heating
mode;
P03: To set the temperature difference between the flow pipe and the return pipe in the floor
heating mode;
P04: To set the temperature difference between the flow pipe and the return pipe for the
domestic hot water (DHW) tank;
P05: To set the DHW tank's activation/deactivation.
P06: To set the domestic hot water offset.
P07: To set the heated temperature compensation
P08: To set the power adjustment (02- 12 team optional)
EN
P09: To set the function of A08 fault detection (00mean OFF/03mean ON)