Ferroli CRONO REM, User Manual

Page: 83 / 244

83
EN cod. 3542A970 - Rev 01 - 03/2022
2.
The value sent is outside the range for this parameter→ the displayed value is limited by the maximum (or
minimum) value.
3. The value sent is outside the range for this parameter → the displayed value remains the same displayed before
the change (the value is rejected).
4. Permanent display of the symbol “- -“: the boiler card does not respond to the Remote Control or the response of
the boiler card is INVALID data.
11. TIMED FUNCTIONs
The timed function implemented by the Remote Control allows the management of a temperature setting for a specific
time interval, after which it returns to the standard management.
The function can be activated when the active operation status is INV.
This function cannot be activated if the ambient probe is not enabled (AMBON = 0).
11.1 Vacation
To activate the function, press the button for more than 3 seconds. The upper digits display (blinking) the
indication of function timing (for example: MM60 means 60 minutes), whereas the lower digits show the setpoint
temperature during the function.
To modify the duration of the function, press the buttons
and . The minimum duration is 10 minutes, the
maximum duration is 45 days.
Once the duration has been set, press the button
to confirm.
The countdown begins in the upper digits and indicates the time remaining until the end of the function. blinks
on the display.
After starting, the function can be stopped with the buttons
or .