Ferroli 30800009, Installation & User'S Instructions

Page: 9 / 20

Installation
ATTENTION!
LED
Button
9
Location
Emergency running mode
If no valid radio signal is received from the receiver for more than 1 hour, emergency running
mode is activated. ED value 12.8 minutes, switch-on time 30%. See page 16.
Radio link installation
1. Install transmitter and select continuous radio operation
system mode. (See page 17)
2. Press receiver button and hold down for 2 seconds. The
LED flashes twice. Then release the button. The LED remains
on between 1 and 10 seconds. When a correct link between
the transmitter and receiver has been established the LED
goes off. Subsequent RF transmissions are indicated visually
by a momentary flash of the LED.
3. Move transmitter to required location and observe LED to
monitor reception. If no reception and appropriate location
must be found.
4. Stop continuous radio operation.
1
2
Note: If no reception is possible it has to be checked whether any metallic
cupboards or other metallic obstacles may interfere.