Not for
Reproduction
16
ferrismowers.com | snapper.com
X 1" bolts (C), 5/16 SAE washers (D), and 5/16-18 hex
nylock flange nuts (E).
35
Install the Winch Quick Mount
1. Mount the winch quick mount (A, Figure 36) to the left
upright tube (B) of the zero-turn riding mower's roll bar
below the folding knuckle (C) of the roll bar.
36
2. Secure the winch quick mount in place using two (2) 3/8
U-bolts (D) and four (4) 3/8-16 hex nylock flange nuts (E).
Install the Weights and Weight Mounts
It is important that the weight carrier and the front weights are
installed whenever the collection system is mounted on your
unit.
Install the Weights and Weight Mount (IS2100Z,
IS3200Z, & F320Z Models)
1. Install the weight carrier (A, Figure 37) onto the front of
the unit and secure with two (2) 3/8 X 1-1/4" bolts (B), 3/8
flat washers (C), and 3/8 nylock flange nuts (D).
37
2. Install the two (2) 50 lbs counter weights (E) in the weight
carrier and secure with the retaining pin (F) and hair pin
clips (G).
Install the Weights and Weight Mount (All Other
Models)
1. Install the weight carrier (A, Figure 38) onto the front of
the unit and secure with two (2) 1/2 X 1-1/4" bolts (B), 3/8
flat washers (C), and 1/2 nylock flange nuts (D).
38
2. Install the counter weights (E) in the weight carrier and
secure with the retaining pin (F) and hair pin clips (G).
See the
"Hopper Weights Needed"
chart below to
determine the correct amount of weights for your unit.
Hopper Weights Needed
Model
Hopper Size
Number of 50
lbs Weights
S200XT
14 cu. ft.
Qty: 3
S200XT
12 cu. ft.
Qty: 2
All other
models
All
Qty: 2
