Not for
Reproduction
16
2.
Grease the front caster.
3.
Remove the 1/4-28 grease fitting and re-install the 1/4-28
bolt.
4.
Repeat process for the other side of the machine.
Check / Fill Transmission Oil
Oil Type: 20W-50 conventional detergent motor oil.
1.
Check the oil level when the unit is cold. Locate the
transmission oil reservoirs (A, Figure 17) positioned by the
fuel tank assembly. The oil should be up to the “FULL
COLD” mark (B). If the oil is below this level, proceed to
step 2.
17
2.
Before removing the reservoir caps, make sure the area
around the reservoir cap and fill neck of the reservoir is free
of dust, dirt, or other debris. Remove the reservoir cap.
3.
Add oil up to the “FULL COLD” mark (B).
4.
Reinstall the reservoir caps.
Storage
Temporary Storage (30 Days or Less)
Remember, the fuel tank will still contain some gasoline, so
never store the unit indoors or in any other area where fuel
vapor could travel to any ignition source. Fuel vapor is also toxic
if inhaled, so never store the unit in any structure used for human
or animal habitation.
WARNING
Never store the unit, with gasoline in engine or fuel tank, in a
heated shelter or in enclosed, poorly ventilated enclosures.
Gasoline fumes may reach an open flame, spark or pilot light
(such as a furnace, water heater, clothes dryer, etc.) and
cause an explosion.
Handle gasoline carefully. It is highly flammable and careless
use could result in serious fire damage to your person or
property.
Drain fuel into an approved container outdoors away from
open flame or sparks.
Here is a checklist of things to do when storing your unit
temporarily or in between uses:
• Keep the unit in an area away from where children may
come into contact with it. If there’s any chance of
unauthorized use, remove the spark plug (s) and put in a
safe place. Be sure the spark plug opening is protected
from foreign objects with a suitable cover.
• If the unit can’t be stored on a reasonable level surface,
chock the wheels.
• Clean all grass and dirt from the mower.
Long Term Storage (Longer Than 30 Days)
Before you store your unit for the off-season, read the
Maintenance and Storage instructions in the Safety Rules
section, then perform the following steps:
1.
Drain crankcase oil while engine is hot and refill with a grade
of oil that will be required when unit is used again.
2.
Prepare the mower deck for storage as follows:
a.) Remove mower deck from the unit.
b.) Clean underside of mower deck.
c.) Coat all bare metal surfaces with paint or light coat of
oil to prevent rusting.
3.
Clean external surfaces and engine.
4.
Prepare engine for storage. See engine owner’s manual.
5.
Clean any dirt or grass from cylinder head cooling fins,
engine housing and air cleaner element.
6.
Cover air cleaner and exhaust outlet tightly with plastic or
other waterproof material to keep out moisture, dirt and
insects.
7.
Completely grease and oil unit as outlined in the
Lubrication
section.
8.
Clean up unit and apply paint or rust preventative to any
areas where paint is chipped or damaged.
9.
Be sure the battery is filled to the proper level with water
and is fully charged. Battery life will be increased if it is
removed, put in a cool, dry place and fully charged about
20
