Not for
Reproduction
19
2.
Fill the fuel tank to the bottom of the filler neck. This will
allow for fuel expansion.
Note: Do not overfill. Refer to your engine owner's manual
for specific fuel recommendations.
3.
Install and hand tighten the fuel cap.
NOTICE
Refer to your engine owner's manual for specific fuel
recommendations.
Check Engine Oil Level
Interval: Before Each Use
Refer to the engine owners manual for dipstick and oil fill
locations and specific engine oil check and fill procedures.
Engine Maintenance
For engine maintenance schedules and procedures, please
refer to the engine operator's manual.
Check / Fill Transmission Oil
Oil Type: 20W-50 conventional detergent motor oil
1.
Check the oil level when the unit is cold. Locate the
transmission oil reservoirs (A, Figure 20). The oil should be
up to the "FULL COLD" mark (B). If the oil is below this
level, proceed to step #2.
20
2.
Before removing reservoir caps (C), make sure the area
around the reservoir cap and fill neck of the reservoir is free
of dust, dirt, or other debris. Remove the reservoir cap.
3.
Add oil up to the full cold mark.
4.
Reinstall the reservoir caps.
Checking Tire Pressures
Tire pressure should be checked periodically, and maintained
at the levels shown in the Specifications chart. Note that these
pressures may differ slightly from the "Max Inflation" stamped
on the side-wall of the tires. The pressures shown provide proper
traction and extend tire life.
Seat Adjustment
The seat can be adjusted forward and back. Move the lever (A,
Figure 21) towards the left, position the seat as desired, and
release the lever to lock the seat into position.
22
