Not for
Reproduction
Mulching consists of a mower deck which cuts and re-cuts
clippings into tiny particles and which then blows them down
INTO the lawn. These tiny particles decompose rapidly into
by-products your lawn can use. UNDER PROPER
CONDITIONS, your mulching mower will virtually eliminate
noticeable clippings on the lawn surface.
NOTE: When mulching under heavy cutting conditions, a
rumbling sound may be present and is normal.
Mulching Requires EXCELLENT Mowing Conditions:
Mulching mowers cannot function properly if the grass is wet,
or if the grass is simply to high to cut. Even more than normal
mowing, mulching requires that the grass be dry and the
appropriate amount is cut.
Do not use the mower as a mulching mower during the first two
or three mowings in the spring. The long grass blades, quick
growth, and often wetter conditions are more suitable for
broadcasting (side-discharging) or grass bagging operation.
Engine Speed & Ground Speed for Mulching:
Use full engine throttle matched with a slow ground speed so
that clippings will be finely cut. Ground speed while mulching
should be HALF of the speed that would be used when
broadcasting (side discharging) under similar conditions. Since
mulching requires more horsepower than broadcasting, using
a slower ground speed is vitally important for proper mulching
operation.
How Much Grass to Mulch:
The best mulching action typically results from cutting only the
top ½ inch to 3/4 inch of grass blade. This provides short
clippings which decompose properly (much more quickly than
longer clippings). The ideal cutting height will vary with climate,
time of year, and quality of your lawn. We recommend that you
experiment with both the cutting height and ground speed until
you achieve the best cut. Start with a high cutting height and
using progressively lower settings until you find a cutting height
that is matched to your mowing conditions and preferences.
Pushing the Rider by Hand
NOTICE
Do not tow rider.
Towing the unit will will cause transmission damage. Do not use
another vehicle to push or pull this unit.
1.
Disengage the PTO, engage the parking brake, turn the
ignition OFF, and remove the key.
2.
Locate the transmission release levers (A, Figure 16)
underneath the engine deck of the machine between the
two rear wheels on the transmission cradle (B).
16
3.
To disengage the pumps (free-wheel position) (C), move
the transmission release lever up and pull it towards the
rear of the machine. When the second nut (D) has passed
through the hole, lower the rod down into the slot so it will
stay in the disengaged position. Repeat the process for the
other side of the unit.
4.
Disengage the parking brake. The rider can now be pushed
by hand.
5.
After moving the unit, re-engage the transmissions (drive
position) (E) by raising the transmission release lever so
that the back nut clears the slot, push the lever towards the
front of the machine. Repeat the process for the other side
of the unit.
CE Units Equipped with Folding ROPS
CE export Units are factory equipped with folding ROPS. Follow
the safety instructions below if your unit is equipped with the
folding ROPS.
Raise and Lower the Roll Bar
WARNING
Avoid serious injury or death from roll over:
• Keep roll bar in the raised position and use seat belt.
• There is no roll over protection when the roll bar is down.
• Lower the rollbar only when necessary and NEVER
remove it.
• Do NOT use seat belt when the roll bar is down.
• Raise the roll bar as soon as clearance permits.
• Do NOT jump off if mower tips.
To lower the roll bar:
20
