Adjusting the speed of the product
1. To increase the speed of the product, rotate
the variable speed dial
4
clockwise.
- - low speed for rough grinding.
- - high speed for fine grinding.
2. To decrease the speed of the product, rotate
the variable speed dial
4
anticlockwise.
Grinding
1. Select the desired speed using the variable
speed dial
4
and then hold the product
securely.
2. Place the sanding pad
1
flat onto the
working surface and switch on the product.
3. Move the product smoothly with gentle
pressure in circular or transverse movements.
4. Once the job is complete, switch off the
product and wait till the sanding pad is
completely stop before putting it down.
5. For ceiling grinding, fix the sanding pad with
the Support spring
17
as shown in Fig. 5.
Cleaning, Maintenance and Storage
WARNING!
Always disconnect the product from the mains
before carrying out any cleaning, maintenance
and storage.
The product shall only be repaired by an
authorised service centre.
Cleaning
1. Keep the ventilation slots free from dust and dirt to prevent overheating.
2. Regularly clean the housing with a soft cloth, preferably after each use. If the dirt
does not come off, use a soft cloth moistened with soapy water
4
7
8
Operation
17
Summary of Contents for YT-7251A
Page 2: ...Overview 2 8 9 4 10 7 6 5 1 2 3 13 16 11 15 17 12 14...
Page 4: ......
