Kapitelüberschrift
28
Set up
m
NOTICE
This chainsaw uses a 4 stroke engine and does not require the mixing of oil
with the fuel.
The chainsaw is fitted with ONE lubrication oil tank (15) and ONE chain oil tank
(17) and a SEPARATE fuel tank (10).
Assembly of the chain bar and chain to the engine unit
m
CAUTION
Do not start the engine until the saw is fully assembled.
m
CAUTION
Wear protective gloves at all times when handling the chain.
Remove the side cover (Fig. 2)
1.
Make sure the chain brake lever / front hand guard (3) is pulled back into the
DISENGAGED position.
2.
Remove the bar mounting nuts (11) with the spark plug spanner (19).
3.
Pull the whole side cover (A) from the engine.
Fit the chain bar (Fig. 2 / 3)
To ensure that the bar and the chain are supplied with oil,
USE ONLY THE ORIGINAL
BAR.
The oiling hole (C) must be kept clear of dirt and any build-up of residue.
1.
Make sure the chain brake lever / front hand guard (3) is pulled back into the
DISENGAGED position.
2.
Fit the open end of the chain bar (1) over the bar pins (D).
To install the saw chain (Fig. 2 / 3 / 4)
-
Spread the saw chain (2) out in a loop with the cutting edges pointing CLOCKWISE
around the loop.
-
Slip the saw chain (2) around the sprocket behind the clutch as shown in figure 3.
Make sure the links fit between the sprocket teeth.
-
Guide the drive links into the groove and around the end of the chain bar (1).
Set up
