4. Bring the sanding belt
19
into the vertical position (see section "Attaching
worktable to belt sander").
18
21
27
19
1. Remove the lower belt cover
21
.
2. Pull off the sanding belt as shown in the illustration.
3. Replace the sanding belt with an equivalent belt.
Pay attention to the belt running direction. The arrow on the inside of the
sanding belt must point in the running direction.
Align the belt so that it is centred (same distance from both outer edges).
4. Now follow the steps in the reverse order to put the device back together.
Adjusting belt tracking
If the sanding belt
19
shifts to the left or right in the running direction, carry out the
following adjustment steps.
Maintenance
26
