ASSEMBLY MANUAL
Whelping Box
Whelping Box in wood for dogs
Whelping Box for dogs in insulated panels
Dear Customer,
Thank you for purchasing a FERRANTI
product.
OBLIGATION
Please consult this assembly manual carefully
before proceeding with any operation on the
product.
INTRODUCTION
This assembly manual reflects the technique at the time of purchase
and the specifications in force at the current date of edition; it
contains the information necessary for correct installation, cleaning
and disposal of the product at the end of its life.
FERRANTI S.R.L. reserves the right to make modifications, changes or
improvements to the manual or to the product at any time and
without notice. Use only the original mounting components provided.
ATTENTION
The manufacturer is not liable for damage to
property, persons and animals caused by accidents due to
failure to comply with the instructions in this assembly
manual.
►
Only use original mounting parts supplied with
the delivery.
INTENDED USE (PERMITTED USE).
The product in question has been designed for the housing
and keeping of animals.
IMPROPER USE (NOT PERMITTED).
Any use other than the permitted one is to be considered
“improper use”; the Manufacturer therefore declines all
responsibility for any damage caused to property, animals
and/or persons.
INSTALLATION
2x
The assembly operations must be performed by at least two persons.
►
For the assembly of the products, the use of Personal Protective Equipment is
always recommended: work gloves to protect the hands from the danger of being
cut.
RECOMMENDED TOOLS
Slotted Screwdriver - Cross Head Screwdriver - Wrench - Cutter.
Note: Tighten the screws completely only at the end and after checking the square
of the structure.
INSTALLATION
- Join the back R to the sides A and B using the
appropriate screws
- At the same time, join the front F to the sides A
and B
- Lift the delivery box and insert the bench P
- Recess the mesh part R on the front F
- Insert the protective edge for puppies C in the
holes located on panels A and B, and secure it with
hooks (fig. 1)
UNPACKING
►
Place the structure near the final installation site and
on a stable and horizontal area of the ground.
►
Remove the packaging materials taking care not to
damage the components.
ATTENTION
RECYCLING
All the packaging materials are recyclable and must be disposed of in accordance
with the local legislation.
SCRAPPING AND DISPOSAL
The materials that compose the structure must be disposed of according to the type
and procedures provided for by the legislation in force in the country of installation.
For further detailed information on the disposal of this product, contact the
municipal office, the local waste disposal service or the store where it was purchased.
