CAPRI LED aquariums
PRELIMINARY WARNINGS
• Check that all parts are undamaged (lights, heater, glass and plastic parts, etc.). Ferplast
uses strong, secure packaging and checks each aquarium individually, but we recommend
you also check that no accidental damage has occurred during transport, storage or sale
which could a
ff
ect its watertight seal and safe use.
• Ensure that the voltage shown on the all electrical components corresponds to that of your
home electrical power supply.
• The aquarium is intended only for indoor use.
• Before switching on make sure your home is protected by an automatic safety breaker
switch (or individual breaker plug) with an operating current of no more than 30 mA.
• Do not connect the aquarium to the power supply before correctly completing all the
installation procedures, including
fi
lling with water.
• Always disconnect all appliances from the electric power supply before carrying out any
maintenance.
• Remember that the protection of the lights from water and dust is guaranteed only when
the
fl
uorescent tubes are correctly inserted and the ring nuts perfectly tightened.
• The light must never be submerged.
• The power cable has Z-type wiring, so if damaged it must be replaced by a quali
fi
ed
electrician.
• All special maintenance work must be carried out by a quali
fi
ed electrician. ‘Special
maintenance’ means any kind of work not included in the paragraph ‘MAINTAINING THE
CAPRI AQUARIUM’ and ‘MAINTAINING THE BLUWAVE FILTER’. ‘Quali
fi
ed electrician’ means
any quali
fi
ed member of the register of installer.
• Never remove the heater (if present) from the water when it is connected to the electric
power supply. Before removing the heater, disconnect it and leave it to cool inside its
housing for at least 5 minutes.
• Check that the
fi
lter intake grilles are not blocked.
• Always ensure that the water level stays above the minimum level and below the maximum;
both are marked on the front of the BLUWAVE
fi
lter. Remember that the water level should
always be between the MIN and MAX levels, both shown on the front of the BLUWAVE
fi
lter
and always at 1.5 cm distance from the lamp.
• Do not damage the silicone cord with scissors, pliers, brushes or scrapers.
• Do not use detergents, solvents or chemical products (descaler, ammonium-based
6
7
GB
RU
PL
DA
SV
HU
CS
SK
ES
NL
D
FR
IT
PT
364432-1_FI CAPRI LED_48pagine.indd 6
18/05/17 17:15