(FWE-INPOD)
IndustriPOD
USER INSTRUCTIONS
HEAD OFFICE: 11 Johnstone Road, Brendale, QLD 4500
Toll Free: 1800 804 647 | Tel: +61 7 3881 4999 | Email: [email protected] | www.ferno.com.au
5. Thread the leg tether strap
through each leg foot of
the IndustriPOD®. (Fig 4)
This operation should be per-
formed by two people.
1. Stand IndustriPOD upright
with legs together (Fig 2)
2. Extend leg lengths to achieve the desired Head
height. To extend legs:
a. Remove the leg pins from
each leg by depressing
the pin release button at
the head of the pin. (Fig 3)
b. When legs are at required height, align the holes on
the leg sections an re-insert the leg pins.
3. With assistance, carefully move the tripod to
the desired location and open the three legs to
maximum width ensuring the feet are correctly
placed as shown in Figure 1 on front page.
4. Double check the leg pins are locked in place and
the tripod is at the correct height.
WARNING: DO NOT attempt to erect IndustriPOD®
over an open hole. Erect IndustriPOD® away from
the hole and move it into the required position once
legs have been extended and locked in to place with
leg pins.
TRIPOD ASSEMBLY
Fig 3
Fig 2
Fig 4
Fig 5
6. When foot tether is threaded through all feet
holes of the IndustriPOD®, feed the tail end of the
foot tether sling through the buckle and tighten,
ensuring there is no slack in the tether. (Fig 5)