20
© Ferno-Washington, Inc. 234-3257-01 December, 2004
Ferno Model 50-E
Setup
6.3 Attaching One-Piece Restraints
Weave the one-piece restraints through the backrest and
leg section as follows:
1. Unbuckle the restraints, raise the backrest and
place the leg section in the highest shock position.
2. Pass a buckle through one backrest slot from back
to front, pull it across the backrest panel and pass
it through the other slot (Figure 19).
3. Partially unzip the fabric cover on the leg section.
4. Thread a buckle through a slot in the cover, pass
it inside the cover and through the slot on the other
side (Figure 20).
5. Zip the cover closed.
6.4 Attaching Harness Components
The harness has two components: a shoulder harness
and a pelvis strap.
ATTACH THE PELVIS STRAP
1. Position the pelvis strap on the seat panel and
make sure the straps are not twisted.
2. Hook the metal bracket to the mounting post on
the main frame. Pull the bracket to seat the post
in the bracket (Figures 21 and 22).
3. Repeat Step 2 to attach the other half of the
restraint to the post on the opposite side of the
stretcher top.
Figure 19 - Attaching a One-Piece Restraint
Through the Backrest
Figure 20 - Threading a One-Piece Restraint
Through the Seat Panel
Figure 21 - Positioning the Pelvis Strap
(Post Not
Shown)
Figure 22 - Attaching the Pelvis Strap
Bracket
Post
