Technical Parameters
Dimensions
Panel (mm): 185(W) ×405(H) ×53(D)
Power supply: 12Vdc/POE
Standby current: 330mA
Working current: 500mA
Technical specifications of the display:
-Size: 10 inch
-Format: 16:9
-Resolution: 1024*600
Camera pixel: 1.2 megapixels
90
o
visual angle: Vertical 72º, Horizontal 54º Minimum illumination: 0.5Lux
Maximum conversation time: 120s
Door relay time: 1-9s
Door delay time: 0-9s
Door sensor time: 120s
IC cards: 100,000
Face data: 10000
Operating temperature:
40
℃
Relative humidity: 20%~80%, without condensation
3.3 FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)
This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Page 11