Ferm ppm1013, Original Instructions Manual

Page: 6 / 84

EN
6 Ferm
• Have the switch replaced.
2. The operating switch is switched on, but
unusual noises can be heard, the motor is
not working or only very slowly.
• Switch contact has fused.
• Have the switch replaced.
• Component jammed.
• Have the electric tool checked or repaired.
• Too much thrust, as a result the motor is
dragging.
• Use less thrust during the task.
3. Motor gets hot.
• Foreign substances have got inside the motor.
• Have the foreign substances removed.
• Lack of or contaminated lubricating grease.
• Have lubricating grease applied or
replaced.
• Pressure too high.
• Use less thrust during the task
• Planing tool blunt.
• Replace the planing tool.
4. The motor is working, but the planing tool
is not moving.
• V-belt worn.
• Have V-belt replaced.
5. Frequent or strong sparks on the
commutator.
• Short circuit on the armature.
• Have the armature replaced.
• Carbon brushes worn out or jammed
• Have the carbon brushes checked.
• Rough running of the commutator.
• Have the surface of the commutator
cleaned or ground
For your own safety, never remove parts or
accessories of the electric tool during operation.
In case of fault or damage have the electric tool
repaired only by a specialist workshop or by the
manufacturer.
Caution!
Use only original spare parts and original plane
blades!
Faults
If a fault arises through wear in an element,
please contact the service address shown on the
warranty card. A drawing of the spare parts that
may be obtained is included at the end of these
operating instructions.
Environment
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
Warranty
Read the terms of warranty on the separate
warranty card which is enclosed.
Please contact the Ferm service address if you
have any questions regarding accessories and/
or batteries.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.