Ferm JSM1020, Original Instructions Manual

Page: 9 / 120

9
EN
● Turn the pendulum action switch (4) to required
position according to the material to be worked.
Refer to the table below to select the required
position.
Material Pendulum position
Wood 1-3
Plastics 1
Aluminium 0-1
Steel 0
Ceramics 0
Rubber 0
Hints for optimum use
● Clamp the workpiece. Use a clamping device
for small workpieces.
● Draw a line to define the direction in which to
guide the saw blade.
● Firmly hold the machine by the grip.
● Set the sawing speed.
● Set the mitre angle.
● Set the pendulum position.
● Switch on the machine.
● Wait until the machine has reached full speed.
● Place the saw shoe on the workpiece.
● Slowly move the machine along the pre-drawn
line, firmly pressing the saw shoe against the
workpiece.
● Do not apply too much pressure on the
machine. Let the machine do the work.
● Switch off the machine and wait for the
machine to come to a complete standstill
before putting the machine down.
CLEANING AND MAINTENANCE
3
Before cleaning and maintenance,
always switch off the machine and
remove the battery.
● Regularly clean the housing with a soft cloth.
● Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
● Regularly clean the saw blade to avoid
inaccuracies during use.
● Regularly lubricate the guide roller.
Replacing the saw blade (fig. B)
Worn or damaged saw blades must be replaced
immediately.
2
Only use sharp and undamaged saw
blades.
● To remove the old saw blade (19), proceed as
described in the section „Mounting and
removing the saw blade“.
● To mount the new saw blade (19), proceed as
described in the section „Mounting and
removing the saw blade“.
STOrAGE
Storing saw blades (fig. F)
The machine is equipped with a special storage
system for saw blades.
● Slightly raise the cover (28) and slide it
backward to open the storage system (17).
● Place the saw blade (19) into the storage
system (17).
● Slide the cover (28) forward to close the
storage system (17).
WArrANTy
Consult the enclosed warranty terms.
ENVIrONMENT
Disposal
8
The product, the accessories, and the packaging
must be sorted for environmentally friendly
recycling.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2002/96/EC
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.