6
EN
Loading the tacker
Before opening the tool, make sure the
tool is switched off.
To load the tacker
Fig. 3 - 4
Replacing staples
• Press the slide unlock (2) to unlock the slide.
• Pull the slide out of the machine
• Place the staples (fig. 4) in the cartridge
• Push the slide back in the machine.
• Lock the slide by sliding the slide forward until
it locks into place.
Using the tacker
• Press the On/Off switch (1) to switch the
machine on
• Press the On/Off switch (1) to switch the
machine off.
• Place the tool on workpiece at the spot where
the staple should be located.
• Press the tool down firmly.
• Press the switch (4).
The tool will cause a re bound because of
the force it operates with. Keep this in
mind.
4. MAInTEnAnCE
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
This machine has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Malfunction
Should the machine fail to function correctly, a
number of possible causes and the appropriate
solutions are given below:
• In case a staple is jammed in the tool, follow
the procedure below
• Switch off the tool
• Carefully remove the staple from the tool
with a thin object (for example a knife).
Repairs and servicing should only be
carried out by a qualified technician or
service firm.
Cleaning
Regularly clean the device’s casing with a soft
cloth, preferably after each use. Keep the fan slits
free of dust and dirt. Remove tough dirt using a
soft cloth, dampened with soapy water. Do not
use solvents such as benzene, alcohol, ammonia,
etc., which might damage the plastic parts.
defects
If a defect appears due to a part wearing out,
please contact the service center on the warranty
card. At the end of these instructions there is an
exploded view of the parts that can be ordered.