Ferm CDM1094, Original Instructions Manual

Page: 5 / 52

EN
5
Ferm
Thermic protector
Do not dispose of in household waste.
Wear ear and eye protection
Wear a dust mask. Working with wood,
metals and other materials may produce
dust that is harmful to health. Do not
work with material containing asbestos
Indoor use only
In case of failure, the transformer is not
dangerous
Do not use in rain
Specific safety instructions
For use of this machine/tool:
• Inspect the surface to be drilled for hidden
electrical wiring, gas pipes or other obstacles
(for example, using a metal detector).
• Check the following points:
• Does the appliance’s voltage correspond
with the mains power supply voltage?
• Are power cords, insulation and plug in
good order: sound, not loose or damaged?
• Is there a good, firm connection at the
mains socket?
• Does the drill show any sign of abnormal
running, overheating or excessive
sparking?
• Whenever any of the problems mentioned
above appear, immediately cease using
the machine and have it repaired by an
expert.
• Wear ear protectors. Exposure to noise can
cause hearing loss.
Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a “live” wire
may make exposed metal parts of the power tool
“live” and give the operator an electric shock.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the mains voltage is
the same as on the type plate of the
machine
Class II machine – Double insulation –
You don’t need any earthed plug
replacement of power cords or plugs
Immediately dispose of old cords and plugs once
they have been replaced.
It is dangerous to plug a loose power cord into a
mains power socket.
Use of extension leads
Only ever use approved extension leads that are
suitable for the power rating of the machine. The
mini mum core thickness is 1.5 mm
2
. Whenever
using a reel extension lead, always fully unroll the
lead.
3. OPErATinG
Hammer drills require very little operator
pressure. Excessive pressure on the
tool can lead to unnecessary
overheating of the motor, and burning of
the driven tool
Exchanging and removing drill bits
Fig. A
Inspect bits regularly during use. Blunt
bits should be re-sharpened or replaced
• Lightly oil the bit shaft before inserting it into
the chuck.
• Slide the locking sleeve (2) to the rear, and
insert the bit into the chuck opening. Ensure
that the keyway in the bit is seated properly in
the chuck, by carefully turning the bit until it
clicks into place. Release the locking sleeve.