Ferimex Outdoor Multi-Router
7
Hardware Installation
1. Assemble the mounting bracket (
9
) and connect it to the back side of plastic housing
of the outdoor unit using 4 screws. The holes for screws are on both right and left
sides, so you can choose where you connect the holder.
2. Mount the outdoor unit to a pipe or a pole. The arrow mark on the back side must
always point up.
3. Plug the Antenna cable to port WLAN1 (
4
) or WLAN2 (
5
) or both.
4. Properly insulate SMA connectors against the water or moisture. Use rubber
insulating tape (not included).
Remember that any small amount of moisture
inside a connector will strongly reduce the performance of the device.
5. Plug the RJ-45 network cable to the ETH1 + POE IN (
1
) port.
6. Plug the other end of the RJ-45 cable to the POE OUT port (
6)
of PoE Injector.
The
PoE Injector is guaranteed only in indoor environment.
7. Connect PoE Injector to your computer or network using the LAN IN port of PoE (
8
)
8a. Outdoor Multi-Router 3-2 and Outdoor Multi-Router 1-1:
Connect the PoE Injector to electrical power using the included power cord.
8b. Outdoor Multi-Router 1-1:
Use the Power Adapter of 10~28 Volts to supply power for the device.
Caution: DON’T plug the Power Cord or Power Adapter into PoE device before you
finish installing the antenna to ensure safety.
We recommend you refer to the following illustration as a guideline for hardware installation.
PC or
Switch
Power
