Ferguson RCU640, User Manual

Page: 8 / 14

4
RCU640 v.2
ENGLISH
Learning Function
The Learning feature is used to supplement
the preprogrammed code list. The
standard code list may provide most of the
functions needed, but you can add a small
number of additional functions for your
remote control. You can add a new code
from a new original remote control.
1. Press BLUE button on RCU-640 without
releasing, and then, press
TV
button. The
POWER button lights up and the remote
control is in learning mode.
2. Point the IR transmitter of the original
TV remote control remotes face to the
IR receiver of RCU-640 by approximately
30 mm apart. Keep two remotes at the
same straight line to make the learning
process more accurate.
3. Press any button on RCU-640 which you
want to learn a new code from original
remote control, (For example, you choose

button) now LED starts to flashing and
RCU-640 is under learning status.
4. Press the one button (for example,  but-
ton) from your TV original remote control.
When POWER button on RCU-640 flashes
three times and stop, it means RCU-640
has accepted new code and now you
can start to learn another new code from
original TV remote.
5. Repeat step 3 to 4 to learn another code
from TV original remote control.
6. When you finish learning all buttons, press
TV button to save all learnt from original
TV remote codes.
NOTE: Only TV device have Learning
Function. You can not learn any new code
for DVD, AMP, and SAT.
NOTE: Total 13 or 30 buttons (depending
on RCU revision) can be used for learning
new codes.
NOTE:
If you want to replace the code you
have learnt into RCU-640, just learn a new
code from original TV remote control.