2. IMPORTANT INFORMATION ABOUT SAFETY! PLEASE READ THESE IN-
STRUCTIONS AND KEEP THEM.
• Do not remove or disconnect the communication module battery to mute a false alarm. In this
case, the detector will lose its alarming features. Ventilate the area around the detector to mute
the detector or press and hold the test button for 3 seconds.
• The test button thoroughly checks all features of the smoke detector. Do not use any other test
method. Test the smoke detector to ensure proper operation.
• If you need help installing the smoke detector, contact a qualified electrician/ monter/ chimney
sweeper. Comply with all local and national electrical and building codes when installing.
• The best solution is to place smoke detectors in every room and on every floor of the building.
Life-threatening smoke may not reach the detector if it is located in a remote place or encounters
barriers (e.g. doors). In such cases, the smoke may not reach the alarm device in time to alert
household members/ staff members. The sensor detects a fire in the room or area where it is
installed.
• The volume of the alarm sound is adjusted to the average hearing capacity to warn household
members/ staff members of a potential danger. However, there may be limiting circumstances
in which a person may not hear the alarm (e.g. outside or indoors noise, use of earplugs, use of
drugs or alcohol, hearing impairment, etc.). A person hearing the alarm must respond quickly to
it to reduce the risk of injury or death from a fire. If the household member/ staff member is deaf,
install special smoke detectors with lights or vibration devices.
• The smoke detector only sounds an alarm when smoke is detected. The sensor checks the com-
position of the air for the presence of particles that may come from the combustion process. The
device does not detect high temperature, flames or gas. This smoke detector is designed to give
an audible warning of a developing fire. In the event of violent fires involving explosions and oth-
ers smoke may not reach the detector quickly enough to allow for safe evacuation.
• The smoke detector does not guarantee 100% protection of life/ health or property against fire.
Smoke alarms are not a substitute for your insurance benefits. The sensor should be replaced after
approximately 10 years. device weekly and replace every 10 years.
3. WHERE TO PLACE THE SMOKE DETECTOR
• In a minimum home configuration, smoke detectors should be placed between the bedroom and
potential fire locations such as the living room and kitchen. In one-story, one-bedroom houses,
the smoke detector should be installed in the hallway, as close to the sleeping area as possible.
To ensure the early recognition of dangers, no smoke detectors should be located more than
3m from a door from a sleeping room. It may be necessary to install more than one smoke de-
tector, especially if the hallway is more than 15 m long. In single-story houses with two separate
bedrooms, at least two smoke detectors are required, one near each sleeping area. In multi-sto-
rey houses, sensors should be installed on the ground floor between the staircase and all rooms
where the fire may spread. Install at least one smoke detector on each floor in communication
areas that form part of the escape route (usually hallway and mezzanines).
• For the best protection, smoke detectors should be installed in every room in the home, except
those listed in Chapter 4 LOCATIONS TO AVOID.
• Smoke detectors should be installed in communication areas at a distance of no more than 7.5 m
from the farthest wall, no more than 7.5 m from the door to any room where fire may start, and no
more than 7.5 m from the next smoke detector.
• The best location for the sensor is usually in the center of a room or hallway. If it is necessary to
place the smoke detector on the wall, always place the detector’s sensor element 150 mm (0.15 m)
GB
