Ferguson AV-660, Operator'S Manual

Page: 21 / 23

20
TEST TONE, LFE TRIMMER AND CHANNEL SELECT.
TEST TONE
Speaker Level balance Adjustment
The test tone function is useful to adjust the relative
volume between speakers in DOLBY DIGITAL or
DOLBY PRO LOGIC II mode.
Once the balance is set, you don’t have to change the
balance as long as the speakers aren’t moved.
1. Adjust
the VOL. +/- to the normal listening level.
(Half of max. Volume is recommended)
2. Press the T.TONE button (on the remote control) in
DTS, Dolby Digital or Dolby PRO LOGIC II mode.
The test tone is emitted from each speaker each time you
press “
T.TONE ”.
T.TONE
VOL VOL
→
L(FRONT LEFT)
→
R (FRONT RIGHT)
→
LS (SUR. LEFT)
→
←
BS
←
SUB
←
C (CENTER)
←
RS (SUR.R)
3. Select a speaker by pressing the
“T. TONE” button
and adjust the level by pressing the VOL. +/- button.
The level of each speaker can be adjusted in 1 dB step
from –10 dB to +10 dB.
4. When the setting is finished, press the TEST TONE
button to stop the test tone.
Note: You must keep press T. TONE until one complete
cycle is finished.
LOW FREQUENCY EFFECT (LFE MIX)
LFE (LOW FREQUENCY EFFECT) MIX LEVEL
(LFE MIX)
Under COAX./OPT mode, when playing , input AC3 or
DTS 5.1CH signal, LFE will appear on the VFD, then
press LFE key on the remote, and again press VOL +/-
key to adjust the level between 0dB to –10dB.
Note: The LFE adjust state resume to normal, if
MASTER VOLUME is not press after 5 seconds.
LFE TRIM
CHANNEL SELECT
Balancing volume between speakers in 6.1 channel
mode when using the 6.1 analogue inputs.
As the Dolby Digital signal is decoded in the external
source, sometimes, you may have to balance volume
between speakers due to the location of speakers. In this
case:
CH
SELECT
VOL VOL
1. Press
“CH SELECT ” on the remote, the following
loop will appear on the display:
→
L(FRONT LEFT)
→
R (FRONT RIGHT)
→
LS (SUR. LEFT)
→
←
BS
←
SUB
←
C (CENTER)
←
RS (SUR. R)
2. Adjust the VOL.+/- to balance all speakers.
The level of each speaker can be adjusted in 1 dB
steps from –10 dB to +10 dB.
Note:
If the Master Volume is not adjusted for 5 seconds
in Channel Trimmer state, it returns to normal state.