34
6. MOUNTING ACCESSORIES
Prior to mounting an accessory
always remove the battery.
6.1 Fitting and removing drill cutters
(Fig. 2)
9
4
Fig. 2
In addition to drills, the tool can also acco
modate screwdriver bits with a hexagonal shaft.
• Loosen the drill chuck (4) by rotating the
hand-grip (9).
• Insert the shaft of the drill cutter into the
chuck.
• Tighten the drill chuck so that the drill cutter
is firmly clamped.
• Rotate the drill chuck in the opposite direc
-
tion when you wish to change the cutter.
6.2 Connecting and removing the bat-
tery (Fig. 3)
10
5
Fig. 3
Ensure that the exterior of the battery
block or tool is clean and dry before
connecting the charger.
• Ensure that the direction reversing switch (6
Fig. 1) is in the central position in order to
prevent the appliance from being switched on
unexpectedly.
• Insert the battery (5) into the base of the app
-
liance, as shown on the illustration. Push the
battery until it latches in.
• Press the locking buttons (10) on both sides
before removing the battery, and disengage
the battery from the base of the appliance.
7. OPERATION
Always follow the safety notes and
the relevant safety code.
Hold the appliance firmly and press the drill
steadily onto the workpiece. Do not overload
the appliance. Only use drills with no visible
wear. Worn drills will have a bad effect on the
functioning of the appliance.
7.1 Adjusting the speed (Fig. 4)
2
LO
HI
Fig. 4
• For slow drilling or for driving or removing
screws, set the speed selection switch (2) to
‘1’.
• For fast drilling set the speed selection switch
to ‘2’.
