4
PANELS
1. Microphone Input Sockets
2. Microphone volume control
3. Echo control
4. Bass control
5. Treble control
6. Master Volume control
7. MP3 Play/Pause/Track buttons
8. Speaker output
9. Line input
10. Power switch
11. AC power cable
OPERATION:
Connect the passive speaker with a good quality speaker cable to the speaker output connector (8).
WARNING:
only connected the original slave speaker on the speaker output terminal!
If required connect an external signal source like a CD-layer to LINE IN (8).
Connect the device with an electric outlet (230VAC / 50Hz)
LINE INPUT (DVD, CD-player etc.):
1. Connect the source (DVD-player, CD-player etc.) to the line input on the rear panel
2. Slide the SOURCE select switch to DVD position.
USB/SD:
1. Slide the SOURCE select switch to USB position.
2. Press PLAY button, MP3 begin to play.
MICROPHONE:
1. Inset the microphone to the MIC1 or MIC2 (1) jack.
2. Adjust the MIC volume (2) and tone control.
3. Adjust the echo control (3).
Adjust the master VOLUME (7)
Adjust the master Equalizer (4+5) to get the right sound
WARNING:
Do not turn the volume at max when use this product at public place just like school, office etc. After long time
using the back panel will be hot, do not touch it by hand.
TROUBLE SHOOTING:
Failure
Possible cause
NO POWER
The power line is cut off or not connected
No power on the electric outlet
NO SOUND
Wrong input, check input selector
The connect line was broken
The volume knob at lowest
ONE SPEAKER WITHOUT SOUND
Connection between master & slave unit wrong
Signal line was broke
MICROPHONE NO SOUND
The microphone not complete connected
Adjust the microphone volume
Change microphone
MICROPHONE HOWL
The microphone is too close to the speaker
Master volume adjust too big
