ES
◎
Cree XP-G (R5) LED with a lifespan of 50,000 hours
◎
Uses two 3V CR123A batteries (Lithium) or one 18650 rechargeable battery (Li-ion)
◎
127mm (Length) x 25.4mm (Diameter)
◎
61-gram weight (excluding batteries and the battery tube)
◎
Digitally regulated output - maintains constant brightness
◎
Reverse polarity protection, to protect from improper battery installation
◎
Over heat protection to avoid high-temperature of the surface
◎
Anti-roll, slip-resistant body design
◎
Tactical tail switch with momentary-on function
◎
Side switch in the head
◎
Made of durable aircraft-grade aluminum
◎
Premium Type III hard-anodized anti-abrasive finish
◎
Toughened ultra-clear glass lens with anti-reflective coating
Notice: The above-mentioned parameters (tested by high-quality CR123A Lithium battery in Lab)
are approximate and may vary between flashlights, batteries and environments.
*The flashlight will transfer into the High brightness level after working about 30
minutes in the Turbo. Therefore, the runtime of Turbo output is an accumulated time.
Operation Instruction
Light turning on/off:
Press the tail switch lightly to activate the flashlight momentarily. And press the switch
completely to turn on the flashlight and lock it. Another complete press on it can turn it off.
On/Off Operation:
Depress the tail switch gently to momentarily activate the light. Depress the tail switch completely
to turn on the light and lock it. Another complete press on it can turn it off.
Mode Selecting:
A single press on the side switch in the head to adjust the brightness levels from Turbo
→
Low
output
→
Medium
→
High
→
circle.
Depress the side switch and hold it for 1 second to enter into Strobe mode.
Depress the side switch and hold it for 3 seconds to enter into SOS mode.
When the flashlight is in Strobe mode or SOS mode, a single press on the side switch to return to
general lighting mode.
The flashlight memorizes the last output in general lighting mode. However, it does not memorize
the mode, so the flashlight works in general lighting mode when it is lighted every time.
Over-heat protection
: PD32 will accumulate a lot of heat when it is working in Turbo output. To
avoid the influence of using experience due to the high temperature, the flashlight will
automatically transfer into the high brightness level by working in Turbo output for over 30
minutes. If the Turbo output is needed continually, just reset it again.
