6
Installation manual
The installation, electrical connection and the first start- up may only be
carried out by a person with an appropriate qualification.
Clearance distances
The distance between the bottom edge of the appliance and the floor must
not be less than 50 mm. The distance at the side, for example from
furniture, must be at least 100 mm and in the upwards direction at least
100 mm (see picture 2).
In bathrooms, the panel must be installed in accordance with ČSN 33
2000- 7- 701 and it is to be placed in accordance with pict. 1 in zones 2
and 3.
The panel is a class II appliance and is protected against splashing water,
IP coverage 44.
The panel must not be placed directly under an electric socket.
It is necessary to equip the electrical installation with a 2- pole switch with
a distance of at least 3 mm between its disconnected contacts (the Fenix
Therm 100 thermostat meets this condition).
Installation
The panel is packed by itself in a cardboard box, and mounting brackets
are used to mount it on the wall. The panel can only be installed verti-
cally. Drill the openings for the brackets according to pict. 4. Dimensions A
are the spacing of the drilled openings and dimensions B, C and D are the
minimum distances of the openings from the surrounding objects.
Attach the brackets to the wall with screws and wall anchors (not part of
the product); these need to be chosen with regard to the material the wall
is made of and the higher weight of the panel. Always hang the panel on
the brackets by the top two screws and attach it tightly to the bracket
using prepared nuts with washers.
Apart from the fixation brackets, adjusting supports are also packed with
the panel; these supports define the clearance distance of the panel from
the wall after they have been screwed to the bottom screws of the panel.
Picture 3 shows the side view of the panel after it has been hung on the
wall.
CAUTION: It is necessary to install the panel in such a way that the rail of the panel
is placed at least 600 mm above the floor.
Attaching the towel holders
— Insert the holder and secure it with the adjusting
screw. Tighten the adjusting screw only slightly;
the holder could snap if it is screwed tighter.
Summary of Contents for GRT Series
Page 5: ...5...
