V
1.0
TM
FENIEX.
2018
INSTRUCTION MANUAL
WEB.
www.feniex.com
6
Geo Series Lightstick Wiring Instructions
Step 5
: For right arrow function, connect the
gray wire to a 12V(+) post (switch). There are
2 different right arrow flash patterns. To select
a pattern, engage the gray wire a 12V(+)
source and momentarily connect the yellow
wire on a 12V(+) source to select the desired
pattern.
Step 6
: In order to achieve a center out directional
pattern, connect both the gray and blue wires to a
12V(+) post (switch). There are 2 different center
out flash patterns. To select a pattern, engage
the blue and gray wire to a 12V(+) source and
momentarily connect the yellow wire on a 12V(+)
source to select the desired pattern.
Step 7
: For takedown steady functionality, connect
the white wire to a 12V(+) post (switch).
Step 8
: For takedown flashing, connect the green
wire to a 12V+ (post). Please note that for dual
color bars, the green wire will activate mode 2,
unless otherwise programmed.
Important Note!
Takedown steady overrides
takedown flashing
Activate Takedown Flashing for Dual Color:
Step 1
: Connect the black wire to the
battery’s 12V(-) ground.
Step 2
: Select the wire that will be set as
the takedown flashing mode wire, either the
green or brown wire.
Step 3
: Twist the selected mode (green
or brown), red, white, and yellow wires
together.
Step 1
: In order to power the unit, extend
the red, 12V(+) wire to the 12V(+) post of
the vehicle’s battery. Extend the black
12V(-) wire to the ground post of the
vehicle’s battery.
Step 2
: To turn the lightstick on, connect the
brown wire to a 12V(+) source.
Step 3
: Momentarily connect the yellow wire
on a 12V(+) source to change flash patterns.
Step 4
: For left arrow function, connect the
blue wire to a 12V(+) post (switch). There are
2 different left arrow flash patterns. To select
a pattern, engage the blue wire to a 12V(+)
source and momentarily connect the yellow
wire on a 12V(+) source to select the desired
pattern.
Step 4
: Power the lightbar on by connecting
the twisted wires to the battery’s positive
(+). Once activated, the takedown steady
function will engage. To verify takedowns
are flashing, disconnect Takedown Steady
(white) wire from power.
Step 5
: Repeat steps 1 through 3 to
deactivate Takedown Flashing.
